Requires a printer with minimum 256x256x160 build volume.
 
Please note the P12 logging bed and trailer shown in the images are SOLD SEPARATELY. This body is for the TRX6 - G63 version.
 
There’s no doubt the P12 has achieved legendary status in its ability to haul extremely heavy loads. This experience can now be lived through in RC form, providing a new aspect to the world of crawling and hauling.
 
Being such a large truck by design, the ideal outermost tyre to tyre width is 265mm, and tyre height of 130mm is recommended. Using 130mm tyres would require purchasing additional Traxxas parts. More information below.
 
Body mounts for the TRX6 are included for easy mounting.
 
The battery is intended to be mounted at the front of the chassis rails where it is easiest to access. The bonnet top flaps are on hinges and can swing open, lower bonnet panels are held on using magnets, giving you immediate access to the battery.
 
A fully detailed interior is included with this body, including dashboard, steering wheel, steering wheel column, pedals, seats, firewall and floor. The interior is also wrapped up in noise proof padding and quilting for a more unique and detailed touch.
 
There are 5 different types of front bumpers included with the body, ranging from the most bulky to a stubby and high clearance type.

 
Features and details included:
Highly detailed interior with floor
Interior door panels
Radiator and grille
Bonnet can open, easy access to battery
Doors can open
Functioning headlight and sidelight buckets
5 different types of front bumpers
2 different styles of exhaust pipes
2 different styles of roof visor
Wipers
And more!

 
130mm tyre conversion:
Using 130mm tyres on the stock G63 will cause clearance issues with the middle and rear axle as the gap between the two tyres at 120mm are already very narrow. Therefore longer links are required for the rear axle. 
 
The idea is to lengthen the rear links by 20mm so that it sets the rear axle further back by 20mm allowing more clearance between the middle and rear axle.
 
Parts list:
Traxxas 8145 (5x115 links with rod ends)
Traxxas 8839 (TRX-6 Ultimate RC Hauler 3XL 298mm T-Lock Cable Set)
Traxxas 8250 (TRX-6 driveshafts)
 
Assembly:
Use Traxxas 8145 as rear lower links, replacing the stock Traxxas 8831 rear lower links.
Use Traxxas 8831 as rear upper links, replacing the stock Traxxas 8832 rear upper links.
Replace stock rear diff lock cable and sleeve with Traxxas 8839.
Mix and match to extend driveshafts for the rear axle.



 
Please note all inner fenders need to be removed to use this body. Aftermarket front shock mounts are required.
 
Printing notes:
Bumper types 1-4 are 270mm in length, but have been tested to fit on a 256x256 bed when rotated 45 degrees on the Z axis


 
Be sure to check out the instruction manual and gather all required hardware for assembly.
 
*It is highly recommended to read the instruction manual before purchasing, to ensure you have all the required tools and hardware to assemble this body.*